During winters, we encounter cold temperatures, which is the critical cause of freezing the water pipes that leading to bursts. Freezing adds massive pressure, which further leads to issues like flooding in the area. However, the good news is that you can protect pipes from freezing. The primary way to prevent it is to make it hot. Besides, there are many more ways of doing which we will check in this article.; However, before we check the five prevention methods, we should eliminate the common myth that it happens only with frozen pipes. Homes in a typically warmer climate also have similar issues when the pipes are not adequately insulated against the frigid temperatures.
Also, if the pipes are in unprotected locations, we will discuss the prevention methods for pipes due to the freezing climate. The cold weather often puts such pipes at great risk. Regardless of your location, it would help if you are worried about the water supply pipes more than other tubes (drain pipes), which are bigger and is made from PVC or plastic, making them flexible enough to sustain. So, how about checking the best five ways to avoid the pipes from bursting during the freezing temperatures, have a look.
1). Maintain the heat
If you are away from your home for a longer duration, you need to ensure to keep your property heated for a long. The homeowners can do it, but the challenge comes with the tenants who may not act to save money on their energy bills. However, convincing them with a valid argument can make them stick to this tip. Generally, heat prevents freezing within the tubes and pipes, keeping away the issues like bursting and water damage within your property. Avoid setting the heat at the higher side, especially when you are away. It will help in keeping the heat on and thus keep the heat away.
2). Allowing the pipe Outlets to Dribble
Opening the faucet will help the connected pipes by allowing a bit that can drip slightly. Opening the faucet can only relieve the pressure within the system. It helps prevent the pressure from piling up within the pipes and will not burst. If you have faucets for cold and hot water, allow both of them to drip the water slightly. It will help prevent the pressure from remaining inside the pipes and bursting them. Lastly, you can set one faucet like the one in the kitchen to warm.
3). Open the interior doors
Generally, we see all the pipes are found in the cabinets. So, when we see the temp going down, you should open the cabinet doors. It allows the heat within your home to enter the cabinet with pipes. It will help in making the pipes warm as well. It can help keep the interior doors open, which can help flow the inside of your entire home.
4). Seal the holes and cracks
It is always good to seal the gaps you find around the holes. These are places where you find the pipes running inside the floors or walls when you see the hold now entering inside the cold air. Also, you must spray the foam insulation, including the excellent stuff for removing the gaps. Make sure to seal the holes over the exterior or interior side of the floor or wall. The low-temperature air entering from outside the cracks and holes creates a section. This area can be freezing and, at times, even freezing.
5). Apply a quality Tape
It works as a bad conductor to the tubes and pipes. It helps provide direct heat to the pipes and tubes, allowing it to make it hot during the cold season. It is an effective solution for pimples found in smaller sections that remains too vulnerable to issues like freezing. It can help in accessing things more accessible to install them over the electric tape and check for diverse problems. You can find two different kinds of tapes. The first one only converts on its own from heat to cold and vice versa. The second type deals with plugging in the pipes when you need heat for them. It doesn’t come with any on and off switch to make it hot or cold. You should use it cautiously as it can be dangerous when you do not use it correctly.